Advertisement
E T C S e r v i c e N o t e
Step 11: Un-mount the power supply by loosening the self locking nuts.
Power
Supply
Step 12: Close the console facepanel and secure it with a quarter turn of the quick release
N o t e :
Step 13: Locate the Reset label from the upgrade kit and place it on the rear panel of the
Step 14: Re-Configure the UPS service Power fail Options Configuration.
Con go ™ Power Su pp ly Up gr ad e Kit Ser vi ce Not e
Congo™ Power Supply Cable Upgrade Kit
a: Locate the connector of the user interface
(facepanel) power.
b: Unplug this connector and plug it into the
direct power supply cable loom. Reference
the graphic below for clarification.
5V / 12V
Transition Board (USB Hub)
5V / 12V
Central Processing Unit
latches.
The console should automatically boot when power is applied. In the unlikely
event that a console does not start after mains supply is applied, it is possible to
start the console by pressing the Reset button. The Reset button functions slightly
different than before this upgrade.
• To reset the console, hold the Reset button for more than 5 seconds. This
will shut down the console.
• To re-start the console after the above step, press the reset button once.
This will power up the console again.
Congo console in the location indicated in the graphic below.
a: Reference the "Congo Power Supply Configuration Service Note" for instructions.
I/O Board
Move connector here!
LABEL
Page 6 of 6
Self locking
nuts
User Interface (Face Panel)
Place label here
El ect r on ic T he at r e Con tr o ls , I nc.
Advertisement
