Advertisement
E T C S e r v i c e N o t e
Step 7:
Step 8:
Con go ™ Power Su pp ly Up gr ad e Kit Ser vi ce Not e
Congo™ Power Supply Cable Upgrade Kit
c: Route the Reset / LED cable loom through the back hole of the EMC cage.
step 6.c
d: Mate connector A (yellow and orange cable) to pins 1 and 3 of connector "front
panel". The yellow cable should be on pin 1 (facing left as shown below).
e: Mate connector B (red and brown cable) to pins 6 and 8 of connector "front panel".
The red cable should be on Pin 6 (facing left as shown below).
f: Secure connector A and connector B in place with a drop of silicone.
connector A
Secure the power cable loom.
a: Add the self adhesive cable tie pad near the
power cable inlet of the EMC cage.
b: Tie down the cable loom to this pad so that
the cable is free of touching the memory
module and all other internal components.
Secure the hard drive and floppy drive cable loom connectors with silicone.
a: Add a strip of silicone on the hard drive and floppy drive cable connectors.
Silicone here
Page 4 of 6
connector B
El ect r on ic T he at r e Con tr o ls , I nc.
Advertisement
