Advertisement
E T C S e r v i c e N o t e
Step 5:
N o t e :
N o t e :
Step 6:
N o t e :
C A U T I O N :
Con go ™ Power Su pp ly Up gr ad e Kit Ser vi ce Not e
Congo™ Power Supply Cable Upgrade Kit
Install the new power supply cable loom #2, provided in the Upgrade Kit.
male
PC Supply
a: Connect the power supply cable loom #2 to the power supply.
b: Connect the first female connector to the hard-disk connector.
c: Route the cable through the opening of the EMC cage.
Be careful to retain the grommet in place around the metal edge of the EMC cage.
d: Connect the second connector to the main board 12V extension.
e: Connect the third connector to the VGA card extension.
f: Route the cable through the opening of the EMC cage.
Be careful to retain the grommet in place around the metal edge of the EMC cage.
g: Connect the fourth female connector to the floppy disk drive.
Install the Reset / LED cable loom provided in the Upgrade Kit.
a: Disconnect the existing Reset / LED cable loom connected between the
transition board and the main processor board.
The Reset / LED loom is a 4 wire assembly (yellow/red/brown/orange).
b: Connect the new Reset / LED cable
loom to J11 of the transition board
4250B5008. This is the connector
next to the USB ports.
Do not connect to the headers near the edge of the board, example J7 / J12.
System damage will occur.
Page 3 of 6
female
1
Hard Drive Power
female
2
ATX 12V Power
EMC Cage
female
3
VGA Card Power
female
4
Floppy Disk
connect
El ect r on ic T he at r e Con tr o ls , I nc.
here
Advertisement
