Table of Contents
Advertisement
When Cook 2 ends, "End"
will show on the Display
and 4 beeps will sound.
(You can stop the beeping
by opening
the door or by
touching
CANCEL.) "End"
will remain on the Display
and a beep
will sound
every 30 seconds
until the
door is opened
or CANCEL
is touched.
The Display
will
then show the time of day.
Hints for Cooking
With More Than One Cycle.
You can program the
cooking
cycles
in any order. However, when the
microwave oven is started,
it will automatically
go through
the cycles
in order-AUTO
SET TIME
- COOK I- COOK 2 (or QUICK DEFROST -
STANDING TIME -COOK I- COOK 2 or COOK I- COOK 2 -AUTO SET TEMP
or PROBE TEMR)
Changing
or Adding
Instructions
You can change
times, Cook Powers, or add cycles
any time before touching
START or during
oven operation.
l
Touch the Cook cycle
you wish to change
or add (COOK 1 or 2).
l
Touch numbers
for new time, if desired.
l
Touch COOK POWER, if change
is desired.
l
Touch number
for new Cook Power, or touch COOK POWER again
if HIGH is
desired.
l
Touch in new cycle
and time, if desired.
. Touch START.
Using AUTO SET
Auto Set TIME and TEMP are preset cooking
cycles
which store commonly
used cooking
times and probe
temperature
settings.
Auto Set TIME
Auto Set TIME provides
ten preset times. One to nine minutes at HIGH Cook
Power can be set by touching
TIME and the corresponding
Number
Pad 1-9.
This provides
a short-cut method
for setting commonly
used cooking
times.
The Auto Set Chart included
with your microwave
oven and the Auto Set
Guide on the inner door panel
help you use Auto Set TIME to cook various
food items without having
to look up the cooking
times.
A preset time of 2 minutes, 30 seconds
at HIGH Cook Power is available
by
touching
just the Auto Set TIME pad. The time may be changed
to any time
from O-99 minutes, O-99 seconds
allowing
you to store your favorite
cooking
time and Cook Power. See page
19 for instructions.
continued
on next page
Advertisement
Table of Contents
