mabe MKR62GWTWB Service Manual page 26

Clothes are
wrinkled
Clothes shrink
Water seen on
inside of door and
top of lint filter
when opening
door after steam
cycle
Small areas on
clothes are damp
after steam cycle
Collars and
waistbands still
wet at end of cycle
Slight variation in
metallic color
Small amount of
water on floor in
front of dryer
Service Engineering
Lint filter is full
Improper or obstructed ducting
Blown fuses or tripped circuit
breaker
Overloading/combining loads
Under-loading
Over-drying
Letting items sit in dryer after
cycle ends
Overloading
Some fabrics will naturally shrink
when washed. Others can be
safely washed, but will shrink in
the dryer
Steam condenses
surfaces
Steam condenses on inner drum
The dryness monitor senses that
the body of the clothes
This is normal
Inadequate load size for steam
cycle selected, excess
condenses inside cabinet
leaks out
• Clean lint filter before every load.
• Check installation instructions for proper
ducting/venting.
• Make sure ducting is clean, free of kinks and
unobstructed.
• Check to see if outside wall damper operates
easily.
• Check the Installation Instructions to make
sure the dryer venting is correct.
• Replace fuses or reset circuit breakers. Since
most dryers use 2 fuses/breakers, make sure
both are operating.
• Do not put more than one washer load in the
dryer at a time.
• If you are drying only one or two items, add a
few items to ensure proper tumbling.
• Select a shorter drying time.
• Remove items while they still hold a slight
amount of moisture. Select a
Damp Dry
• Remove items when cycle ends and fold or
hang immediately.
• Separate large loads into smaller ones.
• To avoid shrinkage, follow garment care
labels exactly.
• Some items may be pressed back into shape
after drying.
• If you are concerned about shrinkage in a
particular item, do not machine wash or tumble
dry it
on these
• This is normal
• If using the
manually reduce the cycle time. If using the
Steam Refresh
the load.
• Choose
damp collars and waistbands. In the future,
when drying a load with is dry collars and
waistbands, choose
• Due to the metallic properties of paint used for
this unique product, slight variations of color
may occur due to viewing angles and lighting
conditions.
• If using the
steam
manually reduce time. If using the
and
Refresh
load.
- 26 -
Less Dry
setting.
Steam Dewrinkle
cycle, add more garments to
Speed Dry Timed Dry
or
More Dry
.
Steam Dewrinkle
cycle, add more garments to the
or
cycle,
to dry
cycle,
Steam