Chapter 2. Installation; Unpacking And Inspection; Rack Mount Installation - Comtech EF Data LBC-4000 Installation And Operation Manual

2.1 U
NPACKING AND
Inspect the shipping container for damage. If the shipping containers are damaged, keep them
until the contents of the shipment have been carefully inspected and checked for normal
operation.
Remove the packing list from the outside of the shipping carton.
•
Open the carton and remove the contents, checking the contents against the packing list.
•
Verify completeness of the shipment and that the unit functions correctly.
•
If damage is evident, contact the carrier and CEFD immediately and submit a damage
report.
•
If the unit needs to be returned to CEFD, use the original shipping container.
2.2 R M
ACK OUNT
The LBC-4000 L-Band Up/Down Converter System is designed for installation in a standard
19-inch (48.26 cm) rack cabinet or enclosure. The converter chassis requires 1-3/4 inches of panel
height space. Adequate air ventilation should be provided on both sides of the rack-mounted
equipment.
If the converter is to be mounted on slides, the slides must be the CEFD rack slides provided with
the converter.
•
Mount the slides on the sides of the converter chassis with the mounting hardware
provided.
•
Install the slide rails in the rack cabinet enclosure.
•
Slide the converter into the front of the rack cabinet until the rear of the front panel
contacts the mounting surface of the cabinet.
•
Secure the converter to the rack cabinet with four screws inserted through the
converter's front panel slotted holes.

Chapter 2. Installation

I
NSPECTION
I
NSTALLATION
2-1