Panasonic CF-T2 Series Reference Manual page 155

Problems with Wireless LAN
Cannot communicate with the access point
Some access points have a function that limits automatic access point detection. Confirm
the access point's SSID using the access point manual, and make the settings manually
on the computer.
The access point wireless function may be disabled.
Confirm the access point's settings according to the access point manual.
If you have installed a firewall, change the firewall's settings to enable communications
from an access point (register as a computer capable of communications, etc.).
Confirm that the following settings match with the access point. If these settings do not
match, confirm the access point settings, and do the settings on the computer again.
• Network name (SSID or ESSID)
• Data encryption
• Network authentication
• Network key
• Key index
Using the following procedure, confirm whether the computer's protocol settings are
correct (only when using TCP/IP).
A When the icon is displayed on the notification area:
Right-click the
When the icon is not displayed on the notification area:
Click [start] - [Control Panel] - [Network and Internet Connections] - [Network
Connections].
B Right-click [Wireless Network Connection], and click [Properties] - [General] -
[Internet Protocol (TCP/IP)] - [Properties].
C
Confirm the protocol settings, such as IP address, and do the settings properly
again.
Depending on the access point and settings, access may not be accepted unless the
computer's MAC address is registered beforehand. In this case, check the computer's
MAC address ( page 152) and register it according to the operating instructions of the
access point.
icon, and click [Open Network Connections].
155