Advertisement
FIGURE 2
FIGURE 3
FCC REGISTRATION INFORMATION
In compliance with FCC Rules and Regulations, Part 68, you are advised that:
1. Before installing your headset, you must notify the owner of the host equipment (i.e.: leasing company).
Provide them with the headset registration number. The number is printed on the headset registration
label.
2. If the installation of your headset requires the installation of a headset jack/JackSet
the internal wiring of leased telephones or other devices, such connections can only be made with per-
mission of the owner of the host equipment.
3. In case of trouble, disconnect your headset to determine the trouble source. If the headset is the
source, modifications or repairs can only be made by the headset manufacturer or its authorized repre-
sentative.
LIMITED WARRANTY AND LIMITATION OF LIABILITY
AT&T warrants to you, the customer, that your AT&T telecommunications equipment will be in good
working order on the date AT&T or its authorized reseller delivers or installs the equipment, whichever is
later ("Warranty Date"). If you notify AT&T or its authorized reseller within two years of the Warranty Date
that your equipment is not in good working order, AT&T will without charge to you repair or replace, at its
option, the equipment that is not in good working order. Repair or replacement parts may be new or
refurbished and will be provided on an exchange basis. If AT&T determines that the equipment cannot be
USAGE
Placing and Receiving Calls with the Headset Amplifier
To place a call, activate the headset. You should hear a dial
1
tone. Dial normally. To end the call, deactivate the headset.
To receive a call, activate the headset. You can now hear
2
and be heard by the calling party. To end the call, deactivate
the headset.
For handset use, pick up your handset as you would
3
normally.
Setting the Volume Control
To increase or decrease the volume to the hearing level most
comfortable for you, rotate the volume control. (Refer to
FIGURE 2)
Quick Disconnect
Your headset model is equipped with a Quick Disconnect
module. This feature allows you to place a call on hold
without removing your headset, thus freeing you to perform a
task away from the phone. Your conversation is quickly
resumed by reconnecting the Quick Disconnect.
Before attempting to use your headset, be sure that the two
1
Quick Disconnect halves are connected.
To put your call on hold, grasp the Quick Disconnect as
2
shown and pull straight apart. (Refer to FIGURE 3)
To resume your conversation, reconnect the two halves of the
3
Quick Disconnect.
®
that connects to
Advertisement
