Removing Packaging; For Convection Microwave Combination Units; Preparing Oven - Bosch BL54 Installation Manual

Removing Packaging

Left and Right Packaging Bracket Removal
For Convection
Microwave Combination
Units
Convection Microwave Shipping Bracket Removal (for Convection Microwave Combination Units Only)

Preparing Oven

• Cut foil wrap in the area of corner posts.
• Remove foil completely.
• Remove top cardboard.
• Remove all top and side cardboard and Styrofoam braces.
• Place oven in front of cabinets where it is to be installed.
• Unscrew unit from Left and Right Brackets as show in "Left and Right
Packaging Bracket Removal."
Note: Bracket remains in packaging base. Unit should stay in packaging base plate until
ready to be lifted into cabinet cutout.
Remove 2 rear support Convection Microwave Shipping Brackets prior to
installation as shown in "Convection Microwave Shipping Bracket Removal."
Place oven in front of cabinets where it is to be installed. Rest it on a jack or other
sturdy support so that it is in line with the cabinet cutout.
English 11