Advertisement
Warning:
If there is no pressure indicated do not attempt to light the
for your Installer or Service Engineer to re-pressurise the system.
To
Light The Boiler
Switch
the On/Off switch, to the left of the control panel on the front of the
On/Off
Switch
1)
In the On position the On/Off switch will be lit with an .amber light If the
does not illuminate check that the electricity supply to the heating
on
and that the controls are calling for the boiler to fire.
2)
At
the same time the red (lockout) light will illuminate. If neither the
(lockout) lamp nor green (run), the upper lamp adjacent to the flame
illuminate then the boiler is up to temperature and will automatically
when the heating temperature drops sufficiently.
3)
After about 8 to 12 seconds the boiler wiii ignite and the red (lockout)
will be extinguished and the green (run) lamp, the upper lamp adjacent
flame symbol, will
The
boiler is now running correctly and will proceed to switch itself on and off
heating
reaches its operating
If the
red light remains illuminated, due to a failure to ignite or an interruption
gas supply,
turn the boiler off, wait for 10 seconds and turn the boiler on
described
above in To Light The
successive attempts contact your Installer or Service
NB:
The Keston boiler is designed for simplicity and hence has no
adjustment.
Gas
Leak or Fault
If
you suspect a gas leak turn off the appliance immediately and contact
local gas region without delay.
If
you suspect a fault with the appliance it must not be used until the
been corrected by a competent
fR6dl
~
illuminate.
temperature.
Boiler.
If the boiler still fails to ignite after
person.
boiler.
Pressure
Gauge
0
Engineer.
'"'-
\
.•••
'<;.'
"
'~.'
..
''',
.
,.'.
Send
.
boiler, to
switch
system is
red
symbol,
start
lamp
to the
as the
to the
again as
three
user
your
fault has
le>
28
\
•
Advertisement
