Keston 170 User Instructions

KESTON CONDENSING BOILER
The Gas Safety (Installation And Use)
gas users. Further information regarding these regulations can be obtained from your
All gas appliances must be installed by competent persons by law in accordance
regulations. Membership of CORGI is indication of such a competent person with
installation.
It is in your interests, and that of
law is complied with. Failure to do so could lead to prosecution.
Introduction
These instructions should be carefully read to ensure safe and
use of your boiler.
The Keston Condensing Boiler series are high efficiency
condensing boilers designed to provide central heating and
hot water supply.
These boilers are supplied for natural gas use but may be
with LPG by installing the appropriate conversion
be carried out by a competent
Servicing
To ensure continual safe and efficient operation of the
recommended that the appliance be checked and serviced as
regular intervals. Generally once per year will be
any servicing must be carried out by a competent person.
Clearances
If fixtures are to positioned close to the boiler the following
clearances must be observed:
Right: 1 mm
&
allow for access for servicing.
Cleaning
Normal casing cleaning only requires dusting with a dry cloth.
more stubborn marks wipe with a damp cloth and finish with a dry
Boiler Setup
1) Check that the gas supply from the gas meter is turned ON
2) Check that the gas tap to the boiler is in the ON position
slot is aligned with the gas tap).
3) Switch on the electric supply to the boiler and controls and set
controls to call for
4) Check the pressure gauge, to the right on the control panel on the
boiler. This should show around 1 to 2 bar pressure for pressurised
Users Instructions
Regulations:
safety, to ensure that the appliance is installed correctly
They are designed for use with fully pumped
person.
Top:
Front: 305 mm. Extended clearance is required to
heat.
1994 impose certain statutory
kit. This
sufficient.
254 mm, Bottom: 127
(Le.
obligations on
Gas Region.
with these
regard to gas
and that the
economical
central heating
indirect sanitary
systems only.
converted for use
conversion must
boiler it is
necessary at
It is the law that
minimum
mm, Left: 1 mm,
the front to
To remove
cloth.
the screwdriver
the heating
front of the
systems.