Adjusting Support Bearings - Grizzly G0636X Owner's Manual

Whenever changing a blade or adjusting
tension and tracking, the upper and lower
blade support bearings and guide bear-
ings must be properly adjusted and locked
before cutting operations.
To adjust lower blade guides:
1. Make sure blade is tracking properly and that
it is correctly tensioned.
2.
DISCONNECT MACHINE FROM POWER!
3.
Familiarize yourself with blade guide controls
shown in Figure 25.
Blade Guide Bearings
Knurled
Knob
Figure 25. Lower blade guide controls (front
view).
Guide Block Assembly Cap Screws
Figure 26. Lower blade guide controls (rear
view).
-26-
Bearing Rotation
Adjustment Bolt
Lateral
Adjustment
Rod Cap
Screw
4.
Follow procedure for adjusting upper blade
guides on Page 24.
Note: The lateral adjustment rod cap screw
and guide block assembly cap screws are
located below the table tilt lock lever (see
Figure 26).
Adjusting Support
Bearings
Whenever changing a blade or adjusting
tension and tracking, the upper and lower
blade support bearings and blade guide
bearings must be properly adjusted before
cutting operations.
The support bearings are positioned behind
the blade for support during cutting operations.
Proper adjustment of the support bearings is an
important part of making accurate cuts and also
keeps the blade teeth from coming in contact with
the guide bearings while cutting.
To adjust upper support bearing:
1. Make sure blade is tracking properly and that
it is correctly tensioned.
2. DISCONNECT MACHINE FROM POWER!
3. Familiarize yourself with upper support bear-
ing controls shown in Figure 22 & 23.
Model G0636X (Mfd. Since 09/18)