Grizzly G0636X Owner's Manual page 27

3.
Familiarize yourself with blade guide controls
shown in Figures 22 & 23.
Guide Block Assembly
Cap Screws
Lateral
Adjustment Rod
Bearing Rotation
Cap Screw
Adjustment Bolt
Figure 22. Upper blade guide controls (rear
view).
Bearing
Rotation
Adjustment
Bolt
Figure 23. Upper blade guide controls (front
view).
4. Loosen lateral adjustment rod cap screw,
loosen support bearing adjustment shaft bolt,
and adjust blade guides until edges of bear-
ings are / " behind blade gullets, as illus-
1
16
trated in Figure 24.
Model G0636X (Mfd. Since 09/18)
Blade Guide
Bearings
Knurled
Knob
Support Bearing
Adjustment Shaft Bolt
Note: The
/ " spacing is ideal, although with
1
16
larger blades it may not be possible. In such
cases, adjust the guide bearings as far for-
ward to the blade gullets as possible, and still
maintain the proper support bearing spacing
adjustment.
Approximately
0.016"
Blade
Gullets
Blade
Guide
Bearing
Figure 24. Lateral adjustment of blade guides.
Make sure that the blade teeth will not con-
tact the guide bearings when the blade is
against the rear support bearing during the
cut or the blade teeth will be ruined.
5.
Tighten lateral adjustment rod cap screw.
6.
Loosen bearing rotation adjustment bolts on
both sides of blade.
7.
Rotate knurled knobs to position bearings
0.004" away from blade.
Note: 0.004" is approximately the thickness
of a dollar bill.
8. Tighten both bearing rotation adjustment
bolts to lock blade guide bearings in position.
-25-