Remote Control - VAKI Heathro Fish User Manual

Heathro Fish Pump Manual
1 Turn off the power at the main switch and open the door of the control cabinet. The door can not
be opened unless the main switch is turned off.
2 Turn on the power in the cabinet by turning the white shaft of the main switch clockwise. There
will now be electric current in components of the cabinet, so avoid contact with any live
components.
3 The Altivar 31 has four buttons and a screen. It should now be rdY the screen. There is an up and a
down button on the left side and esc and ent touch button on the screen.
4 Press (Ent) once and "Set" appears on the screen.
5 Press (Ent) again and "ACC"(acceleration) will appear on the screen.
6 Press (Ent) again and a value will be displayed on the screen. The ACC value is set to 3.0 at the
factory. This value indicates the time in seconds for the main the drive to go from 0 to full speed. A
higher ACC value (longer time period to go from 0 to full speed) will make it easier to have fine
speed adjustments.
7 Use the up / down arrows to adjust to the desired ACC setting. The Factory setting @ 3.0,
corresponds to 2.4 Hz per press of the remote control.
Increasing to 6.0s reduces every remote button press to1.2Hz steps.
The Altivar 31 can go from 0 to full speed of 50 Hz
8 Press (Ent) to save the new value.
9 Press (Esc) to return to the "ACC"
10th Press down arrow to scroll to "dEC" (deccelerate) this time setting the time to go from full
speed to stop.
11th Press enter and the value of dEC will appear on the screen.
12th Adjust to the desired value. The value of ACC and dEC need not be equal. If desired, one can
have fine adjustemt on the ACC to allow a slower rate of acceparation speed up while a coarse
adjustment on reducing speed.
13th Press (Ent) to save.
14th Press (Esc) button repeatedly until 'rdY "on screen
15th Test the new setting and adjust if necessary (Section 4-14)
16th When the adjustment is complete the power is turned off by turning the white shaft of the main
switch counterclockwise.
17th The door of the cabinet is closed.

3.7 Remote Control

Wireless remote control is optional and highly recommended. With
this you can start and stop the priming pump and the main pump,
and control the speed of the main pump. (see page 10 of the
manual)
Inside the control cabinet there is an antennae for wireless
connection to the handheld remote unit.
The remote must be recharged with the battery charger supplied.
www.vaki.is Page 6