Table of Contents
Advertisement
WCS-EIG310
Commissioning
4.5
Network Settings
The interface modul uses implicit messaging. Therefore, any position and speed data is
mapped directly in the controller. The following figure shows the correct setting for integrating
the interface module into the network.
Parameters
Input assembly
Output assembly
Configuration assembly
Minimum RPI
Figure 4.2
You can enter all values with the exception of the values for "Input Size" and "Output Size" on
the input screen of your project planning tool. The values for "Input Size" and "Output Size"
depend on the number of readers and the desired data output. You have to adjust these
according to your hardware configuration.
Values for "Input Size" and "Output Size"
Hardware configuration
1 reader
2 readers
3 readers
4 readers
1 reader with velocity output
2 readers with velocity output
3 readers with velocity output
4 readers with velocity output
Example:
Network settings
Value
101
100
4
20 ms
"Input Size" and "Output Size"
4 bytes
8 bytes
12 bytes
16 bytes
6 bytes
12 bytes
18 bytes
24 bytes
21
Advertisement
Table of Contents
