Advertisement
1-Antenna: pull up the antenna straight before use.
2-Power switch: slide the switch to turn on or off.
3-Power LED: shows the power strength. Green LED shows full power, Yellow LED flashes
when the power is running short.
4-Charging port: charges Ni-Mh or Ni-Cd batteries only. Alkaline batteries are not
rechargeable. NEVER charge your alkaline batteries.
5-Throttle trigger: Please refer to the transmitter diagram.
6-Steering wheel: Please refer to the transmitter diagram.
7-ST-D/R trim: adjust the steering servo angle ranging from 0% to 120%.
8-TH-D/R trim: adjust the throttle servo angle ranging from 0% to 120%.
9-ST-TRIM: adjust the steering neutral position, from 0% to 20%.
10-TH-TRIM: adjust the throttle neutral position, from 0% to 20%.
11-ST-NOR/REV: slide to left or right to choose steering mode.
12-TH-NOR/REV: push the trigger or pull it back to choose the throttle mode.
13-Throttle trigger trim screws: use a hex driver to tighten or loosen the screw to a comfortable
level.
14-Battery compartment cover: to open the compartment, slide the cover to OPEN direction as
indicated, snap it to close the compartment.
15-Battery case: open the battery cover, install 4 pcs AA 1.5V alkaline or rechargeable
batteries based on the "+" & "-" poles. If the status LED flashes red, the transmitter batteries
may be weak, discharged or possibly installed incorrectly. Replace with new or freshly charged
batteries. The power indicator light does not indicate the charge level of the battery pack
installed in the model.
Parts Diagrams
Receiver Functions
Frequency range
2.4GHz modulation
Sensitivity
Working voltage
Working current
Size
Weight
3
: 2.4GHz
: AFHDS
: -100dbm
: DC4.8-6.0V
: 5.7*26*15.2mm
: 11.2g
Advertisement
