Advertisement
E
Information for your safety
Please read all the following information,
which contains important instructions for the
safety,use and maintenance of the
appliance.
This appliance complies with the following EC
Directives:-73/23/EEC,93/68/EEC-Low
Voltage Directive-89/336EEC -EMC Directive.
Never allow children to use the appliance
unsupervised.
Do not use the appliance if the supply
cord is damaged or faulty.
If the main lead is damaged, it must be
replaced by an approved LG Electronics
Service Agent in order to avoid a hazard.
Always switch the vacuum cleaner off
before :
• changing the dust bag.
• changing or cleaning the filters.
If no dustbag is inserted, the cover cannot
be closed. Please do not use force!
Do not vacuum flammable or explosive
substances (liquids or gases).
Do not vacuum hot ash, embers etc.
sharp objects.
Do not vacuum water or other liquids.
How to Use
Connecting the flexible hose
Push the end of the head (1) on the flexible
hose (2) into the attachment point on the
vacuum cleaner.
To remove the flexible hose from the
vacuum cleaner, press on the button (3)
situated on the head, then pull upwards.
Assembling the tubes
(depending on model)
• Plastic (27) or metal (33) tube.
- Fit together the two tubes by twisting
slightly.
• Telescopic tube (4)
- Push spring latch (5) forward.
- Pull out tube to required length.
- Release spring latch to lock.
Using the cleaning head and Accessory
Nozzles
(depending on model)
Fit the large cleaning head onto the end of
the tube.
• The 2-position head (6) is equipped with a
pedal (7) which allows you to alter its
position according to the type of floor to be
cleaned.
Hard floor position (tiles, parquet
floors...). Press on the pedal to lower the
brush.
Carpet or rug position. Press on the
pedal to lift the brush up.
• Hard Floor Nozzle (30)
Efficient cleaning of hard floors (wood,
linoleum, etc.)
• Turbine brush nozzle (31)
- Air adjustment (32)
Slide the air control lever to the right for
long pile carpet and to the left for short
pile carpet.
- Cleaning turbine brush nozzle (29)
Press the button on the rear side of the
nozzle to separate the air cover.
Use the dusting brush & crevice tool to
vacuum clean the brush and fan.
• Crevice Tool (8)
For vacuuming in those normally
inaccessible places i.e. reaching cobwebs,
or down the side of a sofa!
• Dusting brush (9)
For vacuuming picture frames, furniture
outlines, books and other uneven objects.
• Upholstery Nozzle (10)
For vacuuming uphostery, mattresses, etc
The thread collectors help to pick the
threads and fluff.
How to plug in and use
Pull out the supply cord to the desired
length and plug into the socket.
Press button (12) to start the vacuum
cleaner. To stop it press the button (12) again.
Adjusting the power level
(depending on model)
• The flexible hose handle (13) has a
manual air flow regulator (14) which allows
you to briefly reduce the suction level.
• Electronic power control (15)
Suction capacity increases smoothly up to
MAX.
4
Advertisement
