Final Checklist - Bosch HBN 74.. Installation Instructions Manual

FINAL CHECKLIST

To prevent improper connections leading to dam-
age of electrical components and so voiding the
warranty, the following steps must be performed:
1. Check the electrical requirements and make sure
you have the correct electrical supply and that
the oven is properly grounded.
2. Turn on the power supply to the oven. When the
oven is first turned on, a time will flash on the
clock. This is the time of the last power interrup-
tion.
AM
10: 08
3. Check power at the junction box wires using a
volt meter having a range of 0-250 VAC. If you
have installed the oven for use on 240 Volt sup-
ply, you should find that the voltage reading be-
tween the black and red wires (Line to Line)
should be 220 to 240 Volts. If you have modified
the oven(s) for use on 208 Volt, the voltage read-
ing between the black and red wires should be
190 to 208 Volts.
5551 McFadden Avenue, Huntington Beach, CA 92649 • 800/735-4328
09BH0260 • © 2002 BSH Home Appliances Corp. • Litho in USA 1/02
PB
4. Set the clock by following these steps:
a). Touch TIME pad.
b). Turn rotary knob clockwise until CLOCK
appears.
c). Touch TIME pad.
d). Turn rotary knob in either direction. The
time displayed will change in 10-minute in-
crements and indicate AM or PM. Turn the
knob in the opposite direction and the dis-
play will change in one-minute increments.
e). Touch TIME pad. The clock is now set.
5. Test the BAKE mode with the following steps:
a). Touch COOKING MODE pad.
b). Turn rotary knob clockwise until BAKE ap-
pears.
c). Touch START pad. The cooling fan and oven
lights turn on and the word, PREHEAT, is
displayed.
d). The control will beep and the word, PRE-
HEAT, will disappear when the set tempera-
ture (350º F) is reached.
e). Touch CANCEL pad to turn oven off.
6. To check the other oven functions refer to the
Using the Oven Controls section of the USE AND
CARE MANUAL.
7. If the oven is working properly, press the rotary
knob so that it is flush with the oven and turn off
the power supply to the oven.
8. Place the cover on the junction box and make sure
the cover is securely fastened and turn on the
power to the oven.
9. Leave these INSTALLATION instructions as well
as the USE AND CARE MANUAL with the
owner.