Putting On The Carrying Strap; Starting The Engine - Grizzly MTS 43-14 E2 Translation Of The Original Instructions For Use

GB
Warning! If there is any doubt,
seek help with the operation of
this equipment from a specialist in
an authorised service centre.

Putting on the Carrying Strap

(Pic. 9)
Always wear a shoulder strap
when working with the equipment.
Always switch off the equipment
before loosening the shoulder
strap. Risk of accidents.
1. Put on the carrying strap (28) and close
the strap clasp (38).
2. Adjust the strap so it fits tightly.
3. Adjust the strap so the spring clip (39) is
around 10 cm below the hip.
4. Fix the spring clip onto the lifting ring (9)
on the shaft tube of the equipment.
Unhook the equipment before start-
ing the engine and fix it to the carry-
ing strap with the engine running.
pic. 9
9
102
Starting the Engine (Pic. 10)
Start the engine at least three me-
tres from the filling location
Ensure that the protective cap on the
thread cutter (see pic. 7, no. 14) has
been removed.
pic.10
11
7
3
28
38
39
1. Set the On/Off switch (40) on the swit-
ching element (23) to "On"
2. For a cold start set the choke lever
(4) into position
For a warm start leave the choke le-
ver (4) in position
40
42a
42
11
.
.
.
41
4
3