Table of Contents
Advertisement
Flush Channel with Diffuser Installation Guide
2
Node Flush Channel Installation Sequence
Before installing the Node Channel, ensure whenever possible, there is access to both sides.
The Node Flush Channel with Diffuser assembly consists of two mounting angles held together by intermittent
mounting brackets which interfaces with the channel face.
3
9.84
250
MOUNTING WIDTH
A
Suspend the mounting angles and mounting brackets at the required level.
Fix suspension hangers to the mounting angles using the slots provided in the mounting angles.
It is recommended that the Node Flush Channel is supported no more than 150mm from an end or 150mm from any
joint.
Access Cables
Once the mounting assembly is installed, attach the Node access cables to the bridging plate in the mounting assembly
through the hole provided.
Before connecting the channel face to the mounting assembly, connect the other end of the Node access cable to the
flange on the inside of the channel face in the hole provided.
When lowering the channel onto access cable, the face should be lowered gently to avoid damage, ensuring that there
is no-one standing below.
v001 | Flush Channel with Diffuser Installation Guide
FLUSH CHANNEL ISOMETRIC VIEW
5.91
MOUNTING SLOT SPACING
150
FLUSH CHANNEL TOP VIEW
B
118.11
3000
MAX LENGTH
C
Figure 2
BRIDGING PLATE
ACCESS CABLES
Figure 3
35.43
900
MAX RECOMMENDED
SUPPORT SPACING
SLOT DIMENSIONS
10MM X 25MM
D
E
o ALUMINUM EXTRUSION
o ALUMINUM SHEET
o STEEL SHEET
- RECESSED CHANNEL
o ALUMINUM EXTRUSION
o ALUMINUM SHEET
- PLENUM
o STEEL SHEET
FINISH:
- ALL HARDWARE; MILL FINISH
SPECIFIED
ELECTRICAL SERVICE
- SEE SPECIFIC NODE DEVICE
MECHANICAL SERVICE
- CONTACT PRICE SALES REPR
CONTROLS
- CONTROLS BY OTHERS
NOMENCLATURE
- ALL COMPONENTS SHOWN A
UNLESS OTHERWISE NOTED
- ( INSTL BY OTHERS ): PROVID
INSTALLED BY OTHERS
- ( BY OTHERS ): PROVIDED AN
- TBC: DETAILS TO BE CONFIRM
NOTES:
- PRODUCT FINISH MAY VARY
TEXTURE; VARIATIONS ARE W
QUALITY STANDARDS
C
2020-03-25
B
2020-03-12
A
2019-11-27
REV
DATE
TOLERANCES UNLESS OTHE
LINEAR TOLER
u
u
X.X =
0.06" / X.XX =
0.03
ANGULAR TOLER
u
v
X =
1
/ X.X =
PROJECT
NO
DRAWING TITLE
NODE C
SUBMITTAL
2717
NUMBER
© COPYRIGHT PRIC
4
Advertisement
Table of Contents
