Table of Contents
Advertisement
Flush Channel with Diffuser Installation Guide
Cutting Node Channels to Length
Where possible, the channel should be ordered to length based upon contractor site measurements.
If the channel must be cut to length, this should be done at the end, rather than a joint, to minimize visual impact. The
end cap should be removed and reattached after cutting the channel. The maximum length that can be trimmed is
defined by the position of the bridge bracket.
Node Device Installation
Node devices can be integrated into the system at design stage and can be purchased separately from the Node
Channel.
Outer Node housings will be factory installed in the required locations.
The Node devices are installed in the housing by aligning the snap tabs and pushing the inner casing directly into the
housing.
Node Device Removal
To remove the Node device, insert the Node removal tool into the shadow gap between the outer housing and device.
Persuasively slide the Node removal tool anti-clockwise until the Node device is released.
v001 | Flush Channel with Diffuser Installation Guide
Figure 10
Figure 11
INSERT NODE DEVICE
INTO HOUSING
8
Advertisement
Table of Contents
