Philips GC2800 Series Manual page 16

EnGlISh
16
Problem
Water droplets
drip on the
fabric during
ironing.
Water drips
from the
soleplate after
the iron has
cooled down or
has been stored.
Cause
You have not
closed the cap of
the filling opening
properly.
The set
temperature is too
low for steam
ironing.
You have put an
additive in the
water tank.
You have used the
steam boost
function at a
setting below
3.
You have used the
steam boost
function too often
within a short
period.
You have put the
iron in horizontal
position while
there was still
water in the water
tank.
Solution
Press the cap until you hear a
click.
Set an ironing temperature
that is suitable for steam
ironing ( 2 to MAX). Put the
iron on its heel and wait until
the temperature light goes out
before you start ironing.
Rinse the water tank and do
not put any additive in the
water tank.
Set the temperature dial to a
setting between 3 and
MAX.
Continue ironing in horizontal
position and wait a while
before you use the steam
boost function again.
Empty the water tank and set
the steam control to position
0 after use. Store the iron on
its heel.