Automatic Shut-Off Function (Specific Types Only) - Philips GC2800 Series Manual

1 Press and release the steam boost button (Fig. 6).
Vertical shot of steam
You can also use the steam boost function when you hold the iron in
vertical position. This is useful for removing creases from hanging clothes,
curtains etc.
1 Hold the iron in vertical position and press and release the steam
boost button (Fig. 7).
Never direct the steam at people.
Drip stop
This iron is equipped with a drip-stop function: the iron automatically
stops producing steam when the temperature is too low to prevent
water from dripping out of the soleplate. When this happens you hear a
click sound.

Automatic shut-off function (specific types only)

The automatic shut-off function automatically switches off the iron if it
has not been moved for a while.
The red auto-off light flashes to indicate that the iron has been
,
switched off by the automatic shut-off function (Fig. 8).
To let the iron heat up again:
1 Pick up the iron or move it slightly.
The automatic shut-off light stops flashing.
,
If the temperature of the soleplate has dropped below the set
,
ironing temperature, the temperature light goes on.
2 If the temperature light goes on after you have moved the iron,
wait for it to go out before you start ironing.
Note: If the temperature light does not go on after you move the iron, the
soleplate still has the right temperature and the iron is ready for use.
EnGlISh
11