Download Print this page
Ingersoll-Rand Dor-O-Matic 96000 Series Installation Instructions
Ingersoll-Rand Dor-O-Matic 96000 Series Installation Instructions

Ingersoll-Rand Dor-O-Matic 96000 Series Installation Instructions

Slide control

Advertisement

Quick Links

<!Jj)
------------------------------
.
/\
DOR-O-MAIIC@
7350 W. Wilson Ave.
Harwood Heights, IL 60706
Toll Free:
In Illinois:
Sales FAX:
Technical Support
www.doromatic.com
84657-084 REV. B
Dor-O-Matic@
Series 96000 Slide Control
1-800-543-4635
708-867-7400
708-867-0291
1-888-942-9945
Installation Instructions
July 2003

Advertisement

loading
Need help?

Need help?

Do you have a question about the Dor-O-Matic 96000 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Ingersoll-Rand Dor-O-Matic 96000 Series

  • Page 1 <!Jj) Dor-O-Matic@ ------------------------------ Series 96000 Slide Control Installation Instructions DOR-O-MAIIC@ 7350 W. Wilson Ave. Harwood Heights, IL 60706 Toll Free: 1-800-543-4635 In Illinois: 708-867-7400 Sales FAX: 708-867-0291 Technical Support 1-888-942-9945 www.doromatic.com 84657-084 REV. B July 2003...
  • Page 2: Installation

    INSTALLATION Preparation: Refer to Series 96000 Slide Installation Manual (DOM #96000-984) for header preparation instructions. NOTE: Always disconnect main power to operator prior to servicing cleaning. Final Wiring Connections: The Series 96000 header comes from the factory .pre-wired to minimize installation time at the job site. Connect main power the terminal block at the end of the header (Figure 1).
  • Page 3 S[l6OfI ItARI£SS e.<5~'600 (S-esTlM: "):" roll SiZES ll£LOW) A • 79. 6ll. 'JO. Do'-.- •••••• ::::.. Bol~l-1IOO COlflllCK. iIOl ..,., .••.••• '-POSiTQj SIfrlTOt &<218-'JOO ~IIOB ll<117-'JOO (CUT-orr COIl'l'CTOIl) [~E~iSE SfjITCH o:(Y &<223-:100 IlOC~E~ &<225-IlOO (cut-OfT CON~ECTOR) FIGURE 2: ACCESSORY WIRING DIAGRAM Operational Check and Adjustments: NOTE: •...
  • Page 4 Close doors. If the 4-position switch is used, be sure it is in the ~2-wa'l position before proceeding. Apply power to the system using the main power switch on the header/cover. Apply an activation signal (activate inside or outside motion sensor, press keypad -test activate~ or momentarily move the 4-way to the hold position).
  • Page 5 Setting Setting Value Factory Description Display Ranges Default Settlnas Opening speed 1 to 99 Controls the opening speed of the door. It is recommended that the door be operated as slowly as practical for the traffic conditions. Autcrreverse opening 1 to 99 Controls the amount of force required to reverse the door when ooaning (see FEATURES\.