Table of Contents
Advertisement
C O N T R O L B O X O N
C O M P A R T M E N T
P A N E L
( R E M O V E C O V E R )
E X I T
R E M O T E
S T A R T - S T O P W I R E S
T H R O U G H T H I S O P E N I N G
R E M O T E
O P E R A T I O N
C O N N E C T O R
O
COH TROI— REMOTE
a
M O M E N T A R Y
C O N T A C T S W I T C H
SC-1036
FIGURE 8.
REMOTE CONNECTION ON REMOTE START MODEL
BATTERY INSTALLATION AND
CONNECTIONS
The battery cables, battery hold-down frame and
hardware are shipped loose with the generating set.
Battery Cables
Remove and set the gasoline tank along the edge of
the compartment (it is not necessary to disconnect
fuel or vent lines) for ease of connections.
1. Remove control box cover.
2. Insert the eyelet terminal of the long battery cable
(positive +) through the grommet on the bottom
of the control. See Figure 9.
3. Remove the right nut and washer from the start
solenoid.
4. Connect the eyelet terminal of the long battery
cable to this terminal and reinstall the nut and
washer.
5. Reinstall the control box cover.
6. Set and secure the gasoline tank back in the
compartment.
7. Remove the through bolt from the generator
shown in Figure 10 and connect the short battery
cable (negative -) eyelet terminal. Be sure con-
nection is clean and tight after reinstalling the
through bolt.
B A T T E R S
P O S I T I V E ( + )
C A B L E
FIGURE 9.
POSITIVE BATTERY CABLE CONNECTION
Advertisement
Chapters
Table of Contents
