Overload Indicator; Metabo Code! System; What Is The Code! Key Or The Metabo Code! System; Inserting Battery Of Code! Key For First Time / Replacing Battery - Metabo KHA 24 Original Instructions Manual

17026795_0411 KHA 24 14_SPR.book Seite 16 Dienstag, 29. November 2011 2:33 14
ENGLISH
ENG
Removing the tool:
Turn tool lock (2) in direction indicated by arrow
(a) and remove tool (b).
8.7

Overload indicator

LED (7) lights up red and the electronic
system switches off the machine:
The machine was overloaded and the motor
temperature is too high. Actuate the trigger (10) to
switch the machine off and on again and run for a
few seconds while not under load to allow to cool.

9 Metabo CODE! System

9.1 What is the CODE! Key or the Metabo
CODE! System?
The Metabo CODE! System is an electronic
anti-theft device, which can be used to lock your
Metabo tools (with CODE! equipment) and battery
packs (with CODE! equipment) and thus protect
them against misuse. A locked machine (or
battery pack) is no longer functional and is there-
fore useless to a potential thief. You can also
protect your entire machine park (with CODE!
equipment) with a single CODE! Key by transfer-
ring the code to all machines one after the other.
The CODE! Key is not included in the scope of
delivery, but available as an accessory: see
Accessories chapter.
Important note! Ensure your Metabo machine
(with CODE! equipment) is always unlocked
when you send it in for repair or servicing! If
the machine is locked when it arrives, it is
impossible to repair or service it! After
receiving the repaired CODE! machine, it may
be necessary to reprogram the CODE!
machine with your desired code.
16
7
Please following the instructions in the following
chapter in sequence to put the CODE! Key into
operation.
Please obtain information on the use of the
CODE! Key with your cordless tool only from
these operating instructions and not from the
instructions enclosed with the CODE! Key.
9.2 Explanation of the signals on the
LED (6) and (7) on the machine
Press trigger switch (10) briefly to activate the
machine's electronics system.
6
LED (7) lights up green:
The machine is unlocked
LED (7) flashes red:
The machine is locked
LED (6) lights up green:
The inserted batter pack is unlocked
LED (6) flashes red:
The inserted batter pack is locked
( LED (7) lights up red:
Overload indicator, see Section 8.7. )
Note:
When the machine has received a signal from the
CODE! Key, successful reception is confirmed by
short, fast flashing of the LEDs (6) and (7).
Note:
Before the machine can be put into operation,
the machine and
inserted battery pack must be unlocked
9.3 Inserting battery of CODE! Key for first
time / replacing battery
1) Open housing of CODE! Key and carefully
remove pc board.
2) Push battery under the battery retaining
bracket (on the bottom side of the pc board),
ensuring polarity is correct: positive pole (+)
faces direction of battery retaining bracket.
(coin cell battery type CR 2032, 3 Volt)
9.4 Setting new code and transferring to
the machine (and the inserted battery
pack)
Metabo machines (and battery packs) are
unlocked ex works and are thus ready for opera-
tion. Before your machine (and the inserted
battery pack) can be locked, you must first set the
code you have selected at the CODE! Key and
transfer this code to the machine (and the inserted
7
.
.
.
.
.