Auto Program - Panasonic PT-52LCX35-B Operating Instructions Manual

First Time Setup
For your convenience, First Time Set up menu will
be displayed on screen when the set is turned on
for the first time. If needed, follow the menus and
procedures displayed on-screen for setting up the
features.
Language
The language of the on-screen display is set to English
as the factory setting.
You can select English, Spanish or French as the
on-screen displays language.
1
CH Press to select "Language".
VOL VOL
OK
CH
Press to display Language
screen.
2
CH
VOL VOL
OK
CH
Press to select "English,"
"Español" or "Français".
3
Press to go to previous screen.
RETURN
Or, select
OK for same results.

Auto program

You can scan All (Analog and Digital) channels. If
needed, follow the menus and procedures displayed
on-screen for setting up the features. You can also make
the settings in Setup menu.
1
Press to select "Auto program".
CH
VOL VOL
OK
CH
Press to display Auto program
screen.
F i r s t t i m e s e t u p
L a n g u a g e
A u t o p r o g r a m
L a n g u a g e
L a n g u a g e ◄ E n g l i s h ►
icon, then press
F i r s t t i m e s e t u p
L a n g u a g e
A u t o p r o g r a m
2
Press to select "ANT In".
CH
VOL VOL
OK
CH
Press to select "Cable" or
"Antenna".
3
Press to select Mode.
CH
VOL VOL
OK
CH
Press to select "All" or
"Analog".
4
Press to select "Start scan".
CH
VOL VOL
OK
Press to start.
CH
Channels available for
reception will be set
automatically.
5
After Auto Program is complete, the unit will return
to Manual Program mode. To place the channels
that were located by auto scan in memory, move the
cursor to "Apply" and press OK. (pp. 30-31).
If OK is not pressed after selecting OK, the channels
will not be memorized.
Notes:
• After "Auto program" is completed the unit tunes to the first
channel found during "Auto program".
• If setup is incomplete, check connection of Antenna/Cable to
the RF IN Terminal, then try "Auto program" again. (p. 29).
• "Auto program" must be done when you select the input
signal for the first time or whenever you change the antenna
configuration.
• Depending on conditions, "Auto program" may take a while.
A u t o p r o g r a m
A N T I n ◄ C a b l e ►
M o d e A l l
S t a r t s c a n
A u t o p r o g r a m
A N T I n C a b l e
M o d e ◄ A l l ►
S t a r t s c a n
A u t o p r o g r a m
A N T I n C a b l e
M o d e A l l
S t a r t s c a n
Now scanning analog channel ...
Progress
25