Advertisement
Available languages
Available languages
1 x Lamp mount
1 x Lamp set with cable
1 x Frame holder, short
1 x Frame holder, long
1 x License plate mount
2 x
Rail connector
2 x
Connecting element
2 x Metal loop
4 x Wheel stopper
6 x Tensioning belt, small
1 x Safety strap
Specifications
Dead weight:
Payload:
Material:
Electrical connection:
Tow bar requirements
The trailer tow bar must be approved in its construction.
•
Ball and ball rod must have been forged in one piece.
•
Only mount the bicycle rack to a coupling of steel St52-3, grey cast iron GGG52 or higher quality.
•
The D-value of the tow bar ball must be at least 7.6 kN
•
Never mount the rack to a tow bar made of aluminium, other light metals or plastic.
•
Unsuitable ball rods made from GGG40 are produced by Westfalia for the following vehicles:
Manufacturer
Westfalia
Observe the instructions from the tow bar manufacturer. If in doubt, ask your manufacturer directly whether
their trailer tow bar is suitable.
Safety notes
Driving with a mounted bicycle rack will affect the driving characteristics of your vehicle.
Adjust your speed to the new driving characteristics.
•
Never drive faster than 130 km/h.
•
Avoid sudden or jerky steering movements.
•
Remember that your vehicle is longer than usual.
•
Personal injury or property damage due to loss of the bicycles.
Driving without safety straps can lead to accidents.
Before embarking on any journey, check the correct and firm seating of the strap around the bicycles
•
and U-bracket of the rack.
Before embarking on any journey check the correct and firm seating of both straps around the front
•
wheel and the strap around the rear wheel of the bicycle.
If necessary tighten the straps again.
•
Before embarking on any journey, check to make sure the straps used are undamaged and not worn.
•
Damaged or worn straps must be replaced with undamaged ones before you embark on your journey.
•
Only straps authorised by EAL GmbH for the purpose may be used.
Personal injury or property damages caused by protruding parts.
Parts protruding beyond the edge of the vehicle or rack may cause personal injury or property
damage during the journey.
Only mount parts that do not protrude beyond the edge of the vehicle.
•
Personal injury or property damage due to overloading.
Exceeding the maximum payload of the bicycle rack and the permitted supporting load of the trailer tow bar
or permitted overall weight may lead to serious accidents.
Always observe the specifications regarding the maximum payload, permitted supporting load and
•
permitted overall weight of your vehicle. Do not exceed these specifications at any time.
2 x Hexagonal screw M5 x 10
2 x Washer 15.8 x 8.3 x 1.2
6 x Washer 17.6 x 6.5 x 1.1
4 x Washer 11.9 x 6.5 x 0.9
2 x Washer 5.4 x 5.2 x 0.9
4 x
Washer 13.7 x 5.4 x 0.9
6 x
Cable tie
1 x Spanner 13/18
1 x Spanner 8/10/13
1 x Allen key 3 mm
2 x Padlock with key, simultaneous locking
14 kg
36 kg at 50 kg supporting load
46 kg at 60 kg supporting load
max.
50 kg at 75 kg supporting load
max.
50 kg at 90 kg supporting load
Steel, aluminium
13-pin connector
Test symbol
F 4192
F 3830
F 4112
Suitable for
Audi A4
Audi A6
Audi A8
Advertisement
