Panasonic PV-DM2793 Operating Instructions Manual page 31

* Important: I f a remote control button does not work when pressed, press the TV/VCR button on
the remote and try the button again.
Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few
seconds to cancel the Timer
Recording.
• Any future daily or weekly recordings will
be performed as programmed.
ADD/DLT
SELECT
SET
STOP
PROG
Review, Replace or Clear
Program Contents :
( Recording is not in progress )
Repeat steps 1 and 2 on page 30.
1
2
CANCEL : ADD / DLT
SELECT 1 - 8 :
ENTER : SET
END : PROG
3
To Replace program...
DATE START STOP
8 SAT 9:00P 12: 00A 08
TODAY
- - - - - - - - -- - - - - - - -- - - - - - -
SELE CT START DATE
SELECT :
SET : SET BACK :
END : PROG
To Clear program...
P DT START STOP
1 -- -- : -- -- : --
2 8 10 : 00p 12 : 00a 125
3 10 8 : 00p 9 : 00p 10
4 SU 9 : 00p 10 : 00p
SELECT 1 - 8 :
ENTER : SET
END : PROG
Press PROG twice to exit this mode.
4
Notes
• 2 minutes before Timer recording is performed, "PLEASE
PREPARE FOR TIMER REC" appears and/or the PROG
TIMER Indicator fl ashes. Be sure a cassette with record
tab is loaded and the unit is in Stop mode.
• If the start times of two programs overlap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up during a
normal recording or One Touch Recording (page 18), the
Timer Recording will not be performed.
• If there is a power interruption of more than one minute,
the recording may not be performed or continued.
• If "INCOMPLETE" appears after all items have been set,
check all entries and make necessary corrections.
Press to select
the desired program.
CH
1) Press SET to
display.
SLP 2) Press to select
and press SET
or to set new
program contents.
3) Press PROG.
Press ADD/DLT.
CH SPD
-- --
SP
SP
L LP
31 31