Gardenline Xfinity 57431 User Manual page 18

AUS
Assembling
Fig.4
• Place the upper handle on the lower handle (3.).
• Attach the upper handle (4.). Insert the threaded bolt of quickclamping lever
(A) through the holes in the upper handle (B) and the lower handle (D) . Pull
the handles slightly apart and place the spring (C) between the handles on the
threaded bold. Screw the nut (E) a few turns onto the threaded bolt.
• Flip the quick-clamping levers (5.).
NOTE
If is it not possible to completety flip the quickclamping lever, loosen the nut slightly.
Fig.5
• Attach the cable with the two cable clamps (6.).
Assembling the grass catcher (Fig. 6)
• Insert the two lower parts together until it clicks (1.).
• Tighten the two screws at the bottom (2.).
(Fig. 7)
• Fit the upper part and press it together until it clicks (3.).
Attaching the grass catcher (Fig. 8)
• Lift the discharge flap (1.).
• Hook the grass catcher bag into the lawnmower (2.).
• Fold the discharge flap down again (3.).
Adusting the handle height (Fig. 9)
To adapt to the height of the user the handlebar can be adjusted to three different
positions.
• Loosen the quick-clamping lever (1.).
• Move the handle to the desired height (2.).
• Flip the quick-clamping lever.
Adjusting the cutting height (Fig. 10)
The cutting height can be varied in 5 steps from 25 mm (1) to 75 mm (5) with the
cutting height adjustment.
• Pull the handle outwards slightly.
• Set the required cutting height.
• Release the handle again.
Inserting/replacing the batteries (Fig. 11)
• Charge the battery as described in the user manual of the charger.
• Open the battery cover (1.)
18
 support@scheppach.com.au
MODEL: 2x 20V Lawn Mower PRODUCT CODE: 57431 10/2017
AFTER SALES SUPPORT
1300 855 831
