Turning Off The Power - Panasonic PT-AE500U Operating Instructions Manual

Turning off the power

˛ #
POWER
LIGHT
INPUT
COMPONENT
KEYSTONE
MENU
˛ $
ENTER
NORMAL FREEZE
MODE MEMORY
ASPECT PICTURE USER
# Press the POWER button.
B"POWER OFF" is displayed on the
screen.
I I or H H button to select "OK", and
$ Press the
then press the ENTER button.
BThe lamp unit will switch off and the picture will stop being projected.
(The power indicator on the projector will illuminate orange while the
cooling fan is still operating.)
% Press the MAIN POWER switch to turn off the
power after the power indicator on the
projector illuminates red.
BDo not cut power to the projector in any way while the cooling fan is
still operating. Be careful not to switch off the MAIN POWER switch
of the projector or unplug the power cord from the wall outlet.
24-E
NGLISH
% ˛
Power indicator
P O W E R O F F
O K C A N C E L
NOTE:
B During projection of an image, the cooling fan will operate, emitting a
small noise as it operates. Turning the lamp on or off will cause this
noise to increase a little.
B By using the "OPTION" menu to set "LAMP POWER" to "LOW", the
operating sound of the fan can be reduced. (Refer to page 43.)
B You can also turn off the power by pressing the POWER button twice or
by holding it down for at least 0.5 seconds.
B When the projector is in standby mode (the power indicator on the
projector is illuminated red), the projector will still draw a maximum 1.0 W
of power, even when the cooling fan has stopped.
Power indicator
Power indicator status
The projector is in standby mode and image projection
Red Illuminated
is possible by pressing the POWER button.
The projector is preparing for projection after the
power is turned on while the power indicator is
Flashing
illuminated red. (After a short period, a picture will be
Green
projected.)
Illuminated A picture is being projected.
The lamp is cooling down after the power is turned
Illuminated
off. (The cooling fan is operating.)
The projector is preparing for projection after the
Orange
power is turned on while the power indicator is
Flashing
illuminated orange. (After a short period, a picture
will be projected.)
Projector status
E -25
NGLISH