Installation method
Installing the brackets to the projector
Mount the ceiling bracket components onto the projector (sold separately).
Flat washer
Wire rope
"FRONT" inscription
Angle adjusting
bracket
Projector mount
A
bracket
B Securely fasten the projector mount bracket to the
C Put the flat washer through the supplied wire rope
Positions to install
wire ropes
D Put the supplied wire rope through the same wire
E Install the wire rope fixing screws to the projector
Wire rope
fixing screw
F Secure the angle adjusting bracket to the projector
z Tighten the hex head bolts securely in a total of six
z The wire rope is omitted from the illustrations from
Place the projector on a soft cloth or a similar sur-
face, with the bottom surface of the projector facing
upwards.
bottom surface of the projector using 5 hexagonal
bolts with washers (M6 ×16) (included).
fixing screw (M6 x 20).
rope fixing screw.
and tighten them.
z Install the wire ropes to the 2 places in a similar
manner.
mount bracket with 6 hex head bolts.
Attention
areas after adjusting the installation angles as shown
on page 11.
Note
hence on.
9