Cisco Firepower 4100 Series Maintenance And Upgrade Manual page 2

Install the Network Module
Warning
Statement 1040 Product Disposal
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1073 No User-Serviceable Parts
No serviceable parts inside. To avoid risk of electric shock, do not open.
Warning
Statement 1077 Do Not Operate Unit Without Covers
The covers are an integral part of the safety design of the product. Do not operate the unit without the covers
installed.
Hot Swapping
Caution
Note
To remove and replace the network modules that do not currently support hot swapping, power off the chassis,
replace the network module, and then power the chassis back on.
Acknowledgment is necessary if you decommission and physically remove a network module and do not
replace it, or if you replace it with another PID. See the "Acknowledging a Security Module/Engine" topic
in the Security Module/Engine Management chapter in the
Configuration
Step 1
To install a new network module for the first time into an empty slot, do the following:
a) Power down the chassis by moving the power switch to the OFF position.
See Features
b) Follow Steps 4 through 7 to install the new network module.
Maintenance and Upgrade
2
Starting with FXOS 2.3.1, the Firepower 10-Gb and 40-Gb network modules (without hardware bypass
support) support hot swapping, but you must hot swap with an identical network module, that is, a network
module with the same PID. See
network module offline using the appropriate CLI commands before removing the network module from
the chassis so that all network module configuration is saved. See the "Taking a Network Module Offline
or Online" topic in the Security Module/Engine Management chapter in the
Chassis Manager Configuration
We do not recommend that you remove the network module without bringing it properly offline using
the appropriate CLI commands.
You must have ROMMON 1.0.10 or later on the Supervisor to support hot swapping. For the ROMMON
upgrade procedure, see the "Firmware Upgrade" topic in the Image Management chapter in the
FXOS Firepower Chassis Manager Configuration Guide
Guide.
for more information about the power switch.
Product ID Numbers for the network module PIDs. You must bring the
Guide.
for your software version.
Cisco FXOS Firepower Chassis Manager
Maintenance and Upgrade
Cisco FXOS Firepower
Cisco