Table of Contents
Advertisement
Loosen screws and remove the two small plates on the
back of the hood.
Remove the screws in the back of the oven.
Remove
the two Z brackets
from the hardware
package.
Position the hood on the range one inch from the rear
and align holes in brackets (one each side) with holes
in the hood and in the range. (See Figure 18)
MOUNTING
BRACKETS
\
HOOD
.
.
F
.
RANGE
FIG. 18
Fasten the bracket to the hood and range using screws
previously
removed.
To connect ducting or to use vent hood in a ductless
installation, see instructions packed with the vent hood.
See instructions
packed with the vent hood for details
on proper use and care.
When vent hood installation
is finished, go to Step 28,
"Position
and level the range"
on page 6.
77
D Installing
optio
B
D vent hood above
u
conventional eye-
level range
A. The top of the vent hood should be installed against
bottom of overhead cabinets
B. Electrical power supply requires separate ground-
ing circuit
C. See vent hood installation
instructions
for proper
ventilation
and further electrical
requirements.
13
Advertisement
Table of Contents
