Step 9.Sending A Config To The Lcu - Edelbrock QwikData 2 Quick Start Manual

Getting Started
3. On the Menu Bar under File click Open.
4. Select the file named Settings.nsb. All Comms Window Templates are saved with the file extension type
(*.nsb)
5. Double-click the Settings.nsb file or click OK to open it.
The sample Comms window should open displaying all channels and data.
Notes
· For details regarding modifying the Comms screen see Editing Windows in the USB Communication
section of the QwikData 2 Manual or from Help on your QwikData 2 Software Toolbar.
· For details regarding how to Zero Analog channels see Zero Channels in the USB Communication section
of the QwikData 2 Manual or from Help on your QwikData 2 Software Toolbar.

Step 9.Sending a Config to the LCU

Any time a Set-up File is modified in the Configuration Program it must be loaded in the LCU before the
changes can take effect. Follow these steps to load a Set-up File in the LCU.
1. From USB Comms on the Logger menu, click Send Config.
2. The current setup registered to the LCU will be sent to the logger.
A window will display indicating the LCU configuration has successfully been updated.
Notes
· You cannot send a new setup to the logger while it is recording data.
Edelbrock QwikData 2
18