Step 7. Logger Set-Up; Logging Table Enable Conditions - Edelbrock QwikData 2 Quick Start Manual

Getting Started

Step 7. Logger Set-up

Logging Table Enable Conditions

OPTION 1: Your QwikData 2 harness is supplied with two leads labeled LOG-SW and SW-GND for a switch to
manually start logging(Switch in closed position) and stop logging. Select Switch 3 for manual switch override.
The Start Stop Conditions have no effect when the Switch 3 is active.
OPTION 2: Use this function to setup the enable conditions that define when Data Logging starts and stops.
Data Logging will start when either of the start conditions are met but will only stop when both stop conditions
are met. This prevents logging unwanted data like when the car is warming up.
1. On the menu bar under Logger, click Logging Table.
2. Click on the Enable tab.
3. Set the Start logging conditions or select Switch 3 for manual logging switch.
4. Set the Stop logging conditions.
5. Click OK to accept the changes.
Notes
· Cyclic Logging is for continual logging after memory has filled, previously stored data will be overwritten.
· Pit Stop Beacon reserved for future software releases.
Edelbrock QwikData 2
15