Table of Contents
Advertisement
Getting Started
Logging Table Channel Setup
Use this function to enable a channel for logging and setup the sample rates for each of the channels that you
want to log.
1. On the menu bar under Logger, click Logging Table.
The available channels and current sample rates will be displayed (Fig1).
2. Double-click on the channel you want to log and set the sample rate on.
3. Select a sample rate from the available options window (Fig.2).
4. Click OK.
The LCU has a fixed amount of logging memory and has a maximum through put of samples which dictates
the logging rates for channels. If you choose to log channels at a high rate you will reduce the total number of
channels that you can log. If a channel does not vary much during a lap, for example; temperatures, pressures
then choose slower logging rates.
5. Repeat step 3 for the next channel.
6. Click OK to accept the changes.
Notes
· The number of channels enabled and the total logging time is updated each time you make a change.
· Hold the Ctrl key and select multiple channels to change more than one channel at a time.
· The Channel Logging Rate of LCU Battery also controls the refresh rate of the Comms screen. It is
recommended to keep this rate at 50Hz or Higher.
Edelbrock QwikData 2
Fig.1
Fig.2
16
Advertisement
Table of Contents
