Lap/Shoulder Seat Belt Installation - Graco SnugRide SnugLock 30 Instruction Manual

Lap/Shoulder Seat Belt Installation

Always review your vehicle owner's manual for specific
information about your vehicle seat belts.
There are three types of retractors: ELR (Emergency Locking
Retractor), ALR (Automatic Locking Retractor), and
Switchable (ELR switch to ALR). To determine your type of
retractor, follow these steps:
1. Slowly pull the belt out about halfway and
stop.
2. Let the belt retract back several inches.
3. Try to slowly pull the belt out more. If the belt
cannot be pulled any further, it is ALR, ready
to install your car seat. If it can be pulled
further, go to the next step.
4. Slowly pull the belt all the way out, and then allow it to
retract several inches. You may hear some clicking sounds.
5. Try to pull the belt all the way out again. If it cannot be
pulled out, it is Switchable, ready to install your car seat.
If it can still be pulled out freely, it is ELR. Review the
following pages to properly install your infant car seat.
Note: Most vehicles manufactured after 1996 will have
Switchable retractors in the back seat. If you have any
questions about your retractor type, consult your vehicle
owner's manual or call Graco for assistance.
66