Husqvarna PP 455 E Operator's Manual page 13

5. Time
The function is used to measure the amount of time a job
takes. The time is counted from when the saw starts working.
Select:
• ON, to enable.
• OFF, to disable.
• RESET TIME, to reset.
Quit by pressing OK. The main information Status" is then
shown on the display.
When you select time ON (and when the hydraulic unit is
operational, see 1.b) 00:00 is also shown in the lower right
corner of the display. Press arrow down to continue in the
operations menu.
The total time that the hydraulic unit has been operational is
shown here. The time is stated in hours and minutes
(hhhh:mm).
7. Battery status (only machines equipped
with a radio)
This function checks the remote control's battery. Different
messages are shown on the display, depending what is
currently happening with the battery:
• 0% BATTERY 100%
When the remote control is connected and the battery is
being charged a horizontal column is shown below the 0 % -
100 % scale. The column length against the scale shows how
much of the charge remains in the battery.
• CHARGING THE BATTERY
Shown when the remote control is connected and the battery
is charging. The charging time from 0 % to 100 % is
approximately 9 hours.
• BATTERY FULLY CHARGED
Shown when the battery is charged to 100 %.
• BATTERY DISENGAGED
Is shown when the battery is disengaged from the remote
control. The message is also shown when the charging unit in
the remote control has been damaged.
Charge the battery
IMPORTANT! This chapter only concerns machines
equipped with a radio.
The remote control is equipped with a 7.2 volts battery. The
emergency stop on the remote control should always be in the
extended position when charging.
The battery can be charged as follows:
With the Canbus cable (Part No. 531 11 50-12)
With the charging cable to the 12 volts outlet in the car (Part
No. 531 14 20-92)
With the charging cable to the battery charger (Part No. 531
11 72-54)
SETTINGS AND ADJUSTMENTS
With the Canbus cable
Connect the Canbus cable between the remote control and
the unit. Make sure that none of the emergency stops are
pushed in and that the power unit is voltage fed.
Display CHARGING THE BATTERY".
The power unit can be used during charging.
Charging takes approximately 10 hours.
With the charging cable
Connect the charging cable between the remote control and
the 12 volt outlet in the car. Check that the emergency stop on
the remote control is not pushed in. The display shows
CHARGING THE BATTERY when charging is in progress.
The charging time is approximately 6 hours.
CAUTION! ONLY 12 V.
To charge with the battery charger
Connect the charging cable between the remote control and
the battery charger. Now connect the battery charger to a 230
volts mains socket. Check that the emergency stop on the
remote control is not pushed in. The display shows
CHARGING THE BATTERY when charging is in progress.
The charging time is approximately 6 hours.
CAUTION! ONLY 230 V.
8. Radio channel (only machines equipped
with a radio)
When the remote control is only used in battery mode, a radio
antenna must first be connected to the unit:
Remove any cable connection.
Push in the antenna's connector in the socket on the hydraulic
unit. Make sure that the slot in the antenna connector aligns
in the socket.
Screw on the connector's ring on the socket.
A radio channel must be selected when the antenna is
connected.
Select:
0, 1 or 2
Confirm the selection by pressing OK and then arrow down.
The main information Status" is then shown on the display.
Press arrow down again to continue in the operations menu.
– 13
English