Hobby SIESTA VAN Manual page 139

10-11
Built-in devices
Reading out the warning code
In this case, the warning will not be acknowledged on the control
panel and the warning icon will continue to be displayed. The
control panel will remain in a warning state. Other connected
devices can be operated.
- Use the adjusting knob / pushbut-
ton to select the icon.
- Press the adjusting knob / push-
button. The current warning code
will be displayed. Use the error
list to determine the cause of the
warning and eliminate it.
W = Warning
42 = Error code
H = Heating
Cause eliminated / Return to
setting mode
- Press the adjusting knob / push-
button.
Cause not eliminated / Return to
setting mode
- Press the reset button.
Malfunction
If there is a malfunction, the control panel will immediately go to
"Malfunction" mode and display the Malfunction error code.
Due to an internal lag feed in the connected devices, this may
take a few minutes.
If the cause has not been eliminated, the malfunction will occur again
and the control panel will once again go to "Malfunction" mode.
In this case, the malfunction will not be acknowledged on the
control panel and the warning icon will continue to be displayed.
The device will remain in a state of malfunction. Other connected
devices can be operated.
E = Malfunction
41 = Error code
H = Heating
Cause eliminated / Return to
setting mode
- Press the adjusting knob / push-
button.
- The corresponding device will be
restarted.
Cause not eliminated / Return to
setting mode
- Press the reset button.