Chimney Requirements - Travis Industries Endeavor Manual

Stove Installation

Chimney Requirements


DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE.

UL 103 HT Chimney must be used from the first ceiling or floor penetration to the chimney cap.

Use 6" diameter type UL 103 HT chimney from one manufacturer (do not mix brands) or code
approved masonry chimney with a flue liner.

Chimney must be fastened to each adjoining section.

Follow the chimney manufacturer's clearances and requirements.

Use the chimney manufacturer's fire stops, attic guards, roof supports, and flashings when passing
through a ceiling.

No more than 180
entire system (connector and chimney).
NOTE: Additional elbows may be allowed if draft is sufficient. Whenever elbows are used the draft is
adversely affected. Additional chimney height may be required to boost draft.
(a) Min. System Height 15'
Max. System Height 33'
(b) Roof Penetration and Termination (see
chimney manufacturer's requirements)
(c) Chimney Sections
(d) Floor Penetration (see chimney manufacturer's
requirements)
(e) Min. air space to combustibles (see chimney
manufacturer's requirements – typically 2")
(f) Connector – see "Chimney Connector" on the
previous page.
Draft is the force which moves air from the appliance up through the chimney. The amount of
Drafting
Performance draft in your chimney depends on the length of the chimney, local geography, nearby
obstructions and other factors. Too much draft may cause excessive temperatures in the
appliance and may damage the heater. Inadequate draft may cause backpuffing into the
room and `plugging' of the chimney. Inadequate draft will cause the appliance to leak smoke
into the room through appliance and chimney connector joints. An uncontrollable burn or
excessive temperature indicates excessive draft.
© Travis Industries
o o
of elbows (two 90 elbows, or two 45
2/1/2019 - 1507
(for qualified installers only)
o o
& one 90 elbow, etc.) may be used for the
b
c
}
d
}
f
11
}
b
e
a
f
Figure 4
Endeavor II