Husqvarna 333R Workshop Manual page 39

Angle gear
Dismantle the bearings from the output
and input axles.
503 97 64-01
Drive axle
Dismantle the sleeve (B), the drive axle
and guide (A) to check for wear and
possible replacement.
Lubricate the drive axle with grease
when assembling.
503 80 17-01
Dismantle the bearings from the output
and input axles with the help of a small
bearing puller.
TIP!
Hold the bearing puller in a vice so that
it gains a better grip around the
bearing.
Assembly
Clean all component parts and replace
if damaged or worn.
Fit the bearings on respective axles.
This is easier if the bearings are
heated to approx. 110°C using a hot air
gun.
The bearings on the input axle are
sealed on one side. Turn the bearings
so this side faces outwards.
NOTE!
Do not forget the circlip (A)
holding the bearing on the input
axle.
Heat the gearbox to approx. 110°C and
first place the output axle in position
and then the input axle.
Make sure the bearing bottoms in its
seating.
Fit the circlips (B) and (C). Make sure
they lie correctly in their grooves.
Assemble remaining parts in the
reverse order as set out for dismantling.
NOTE!
Do not forget to fill the gear
housing to approx. 3/4 with gear
housing grease 503 97 64-01 once
the plug (D) has been removed.
Drive axle
The drive axle can be easily pulled out
of the shaft for inspection or
replacement.
The axle is guided with the help of a
star shaped, long guide (A).
Dismantle the sleeve (B) with the help
of a screwdriver or knife.
The guide (A) can now be pulled out of
the shaft for possible replacement.
Lubricate the drive axle with grease no.
503 80 17-01 when assembled in the
guide.
5
37