Elson BUSHPEX Product Information And Installation Manual page 18

If the battery Crimp-On Tool does not fully compress what
must I do?
• Release the trigger and jaws by actuating the retract slide
• Recharge the battery or replace with charged battery
• Crimp the joint a second time and check with the crimp
gauge
Do I need to inspect the pipe end prior to crimping?
YES , always inspect the pipe and ensure it is cut square, has
been "rounded & deburred", has no rough edges and the
internal and external pipe is undamaged prior to crimping.
Do I need to "calibrate" the pipe prior to every crimp joint?
YES – this is a requirement for every joint - ensure that the
reaming / calibrating tool suits BUSHPEX Crimp-ON Pex Pipe
Do I need to inspect the crimp fitting prior to every crimp
joint?
YES – you should visually inspect each fitting to ensure it is
free of any dirt and grit, has both "0" rings intact, the
stainless crimp sleeve is properly located and all parts are
undamaged - clean / replace / discard as required.
How can I tell if the pipe has been pushed into the fitting
properly?
• Inspect the fitting to ensure the pipe is visible through all
4 witness openings
Do I need to check every crimp joint has been compressed
properly?
YES – you should check every crimp joint has been
compressed properly by testing with the crimp gauge
6
18