Advertisement
Installation Instructions
Follow these instructions to install a Model L10 switch into a rack.
1. Unpack the Model L10 switch's fixed rack-mount kit and verify that all ordered parts
Table 1. Parts supplied with the Model L10 fixed rack-mount kit
Part
Figure 1. Rack assembly
2
2006 Model L10 Storage Switch
are present. See Table 1 for a list of parts and the quantities supplied.
Description
Rack-mount tray assembly
1
Rear mounting rail
2
Caged nut, for racks with square holes
3
Clip nut, for racks with round holes
4
Screw, hex, M6 x 16
5
Stop brackets
6
Cover panel
7
If any components are missing, contact a customer service representative
6
immediately. (Parts
Note: The rack-mount tray must be mounted using the 5/8-inch gap intervals. The
tray assembly will not mount properly using the 1/2-inch interval. At least 1U of
vertical space is necessary to accommodate the rack-mount tray assembly.
7
and
are shown in Figures 2 and 3, respectively.)
Quantity
1
2
12
12
12
2
1
Advertisement
