Husqvarna 123HD60 Workshop Manual page 6

1
4
Starter
WARNING!
Protective glasses should be worn when working
on the starter to avoid injury to the eyes if, for some
reason, the return spring should fl y out.
Dismantling
Remove the 4 bolts and lift off the starter.
502 50 19-01
Loosen the spring tension.
Lift up the starter cord on the starter pulley
and allow it to rotate backwards until the
spring tension ceases
Remove the screw (A) and lift off the drive
disc (B).
Remove the starter pulley (C).
Dismantling
Remove the 4 screws and lift off the
starter and the underlying guiding plate.
Loosen the spring tension.
Pull out the starter cord about 30 cm.
Slow the starter pulley with your thumb.
Lift the starter cord up out of the cut-out
on the starter pulley.
Let the starter pulley rotate backwards
until the spring tension ceases.
WARNING!
Be careful not to injure your thumb
when the starter pulley rotates in
reverse.
Dismantle the screw (A) in the centre of
the starter pulley.
Remove the drive disc (B).
Carefully remove the starter pulley (C)
together with the pressure equalisation
spring and the recoil spring.
WARNING!
Wear protective glasses.
The return spring lies tensioned
in the starter housing and can fl y
out and cause personal injury with
careless handling.