Husqvarna 123HD60 Workshop Manual page 13

Electrical system
Dismantling
Dismantle the following:
The cylinder cover, the spark plug, the
fan housing cover with fi tted starter, the
heat guard above the muffl er (A) and the
cylinder cover (B).
502 50 18-01
Dismantle the ignition module.
502 50 19-01
Fit the piston stop, 522 43 18-01 and
dismantle the drive disc cup.
522 43 18-01
NOTE!
Place the piston stop so that it is trapped between the piston stop and the
combustion chamber. It must not stick out into the exhaust port.
Remove the nut holding the fl ywheel.
Dismantling
The following components must be
dismantled for the ignition system to be
accessible:
The cylinder cover, the spark plug, the
fan housing cover with fi tted starter, the
heat guard above the muffl er (A) and the
cylinder cover (B).
Separate the short-circuit cables (C).
Remove the screws (D) and remove the
ignition module (E).
NOTE!
Do not lose the insulation sleeves
that are placed between the ignition
module and the cylinder.
Fit the piston stop, 522 43 18-01, in the
spark plug hole.
Remove both screws (F) and remove the
drive disc cup.
Remove the nut holding the fl ywheel.
2
11