Table of Contents
Advertisement
REPLACING
FRONT
I
NDICATOR
BULBS
Remove cab front panel lining, disconnect cable from indicator lamp and
remove hexagon nut.
Remove
two screws in rim,
take
rim with lens and
gasket off and change bulb.
When
installing, the lugs on the inside of
the
bulb holder must engage in
the slots in the housing welded to the body and the rubber gasket must
seat properly on the
front
panel.
Do
not overtighten hexagon nut.
REPLACING
THE REAR INDICATOR
OR STOP AND TAIL LIGHT
BULBS
Remove
two
Phillips
screws, take out glass insert and replace damaged bulb:
Top
-
Indicator
bulb
Bottom -
Stop
and tail light bulb.
When replacing
the stop and tail light
bulb,
the
retaining
pin
nearest to
the
bulb glass must point downwards.
The Phillips
screws in the glass insert
should be tightened evenly but not excessively.
REPLACING
LICENSE
PLATE
LAMP
BULB
Open
engine compartment lid, take bulb holder out and change bulb.
Ensure
that the contact springs are clean and correctly tensioned so that the bulb
fits tightly and makes good contact.
54
Advertisement
Table of Contents
