Canon TR8600 Series Online Manual page 353

Note
• Use 2.4 GHz frequency band to connect to a wireless router. Match the network name (SSID) set for the
printer with that for 2.4 GHz frequency band of the wireless router.
To check the network name (SSID) set for the printer, display it using the operation panel of the printer or print
out the network setting information of the printer.
• Display on the touch screen.
LAN settings
• Print the network settings.
Printing Network Settings
Make sure the printer is not placed too far away from the wireless router.
Check4
If the distance between the printer and wireless router is too far, wireless communication becomes poor. Place
the printer and wireless router close to each other.
Make sure wireless signal is strong. Monitor signal strength and move printer
Check5
and wireless router as necessary.
Place the printer and wireless router where there are no obstacles between them. Wireless communication
between different rooms or floors is generally poor. Wireless communication can be impeded by building
materials containing metal or concrete. If the printer cannot communicate with the computer over a Wi-Fi due to
a wall, place the printer and the computer in the same room.
In addition, if a device like a microwave oven that emits radio waves of the same frequency bandwidth as a
wireless router is nearby, it may cause interference. Place the wireless router as far away from interference
sources as possible.
Check the signal strength on the touch screen.
Using Touch Screen
Make sure Enable bidirectional support is selected in the Ports sheet of the
Check6
Printer properties dialog box. (Windows)
If not, select it to enable bidirectional support.
Make sure security software's firewall is off.
Check7
If your security software's firewall is on, a message may appear warning you that Canon software is attempting
to access the network. If this warning message appears, set security software to always allow access.
If you are using any programs that switch between network environments, check their settings. Some programs
use a firewall by default.
If printer is connected to an AirPort Base Station via LAN, make sure you use
Check8
alphanumeric characters for network name (SSID). (macOS)
If the problem is not resolved, click here and redo setup.
353