GE VAT20 Series Instruction Manual page 29

Fn_05 = 1,2,3
50 Hz standard motor
%
Derating
100
90
60
20 50 (Figure 1)
Fn_19: Multifunction input terminal 1 function = 1~5 or 6 (*)
Fn_20: Multifunction input terminal 2 function = 1~5 or 6 (*)
(*)Only for drives with CPU version from 1.9 ( Check function F_29)
1. Fn_19, Fn_20 =1 : JOG
2. Fn_19, Fn_20 =2: Sp1 terminal
Multi-speed control
TM2 SP1 Terminal
OFF
TM2 SP1 Terminal
OFF
3. Fn_19, Fn_20 =3: External emergency stop signal
When the external emergency stop signal is activated, the inverter proceeds to decelerate and
stop, (ignoring the setting of Fn_14). The inverters E.S. light will flash after stopping. After the
emergency stop signal is deactivated, turn the RUN switch OFF and then ON again to cycle it.
(Fn_10 =1) Or, push the RUN key (Fn_10=0). The inverter will then resume operation and
restart. If the emergency stop signal is removed before the inverter stops, the inverter will still
execute the emergency stop.
Fn_05 = 4,5,6
60 Hz standard motor
Derating %
100
90
60
Decay
20 60 (Figure 2)
(Only for drives with CPU version from
F_19=2 and F_20=6
ON
ON
F_19=6 and F_20=2
ON
ON
TM2 RESET Terminal
OFF
ON
ON
T M2 RESET Terminal
OFF
ON
ON
27
Minute
1.0
(Figure 3) 100 150
1.9)
Output frequency
SP1 (F_08)
SP2 (F_26)
SP3 (F_27)
Output frequency
SP2 (F_26)
SP1 (F_08)
SP3 (F_27)
Percentage of
Current