Setpoint - Re US3 User Manual

Re
S.p.A.

Setpoint

The input allows to vary US3 sensor output according to your own requirements. Input signal value must
be between 0V and 10V. It is also possible to connect an external potentiometer, as indicated in Electrical
connection diagram section.
Varying setpoint signal, output value will depend on target distance and on input signal, as shown in the
following graph.
100 %
50 %
If you decide to reverse regulated output (F7 function) setpoint variation will intervene on output itself as
shown in the graph below:
100 %
50 %
Rev.12/04/11
Output value
[mA] o [V]
0
Output value
[mA] o [V]
0
Reel
max
diameter
Reel
max
diameter
US3
19/23